The
measuring method is based on a low resistive measuring rod which dips
into a conductive liquid and sends a high frequent current to the
tank wall. The
voltage drop between the rod and the tank wall is measured in proportion
to the length of the wetted part of the rod and its total length.
This output voltage is proportional to the tank filling level.
The
level measuring device LSP 05x is ideally suitable for measurements
in small vessels with pasty or strong adhesive media, such as ketchup,
honey and toothpaste. The integrated electronics provide an output
signal from 4 to 20 mA. On the media side a maximum pressure of 16
bar and a permanent temperature from -20 up to 140°C are possible.
Due to the high temperature limit the device is well suitable for
CIP and SIP processes.
All
parts in direct contact with the media are made of stainless steel
or PEEK. The Teach-in procedure allows programming of the minimum
and maximum level at any interval from 50 mm upwards. The maximum
rod length is 3 meters.
The
excellent metering accuracy of 0.1 per cent of the respective rod
length and the short response time of Tm=10 ms enable a precise level
control. A stabilised voltage supply of 18 to 36 VDC at 200 mA guarantees
secure operation.
For
the installation in a conical tank bottom the instrument can also
be mounted with an angled rod. Furthermore, a version with separate
rod sensor and electronics is available.
Germany - Press
Contact:
Konzept
PR GmbH, Andrea Finkel
Karolinenstr. 21, 86150 Augsburg
Tel.: +49 (0)8 21-343 00-15
Fax: +49 (0)8 21-343 00 77
E-Mail: a.finkel@konzept-pr.de
Internet: www.konzept-pr.de
Spain
- Press Contact:
Rafaela Almeida
Marketing & PR Manager
BlaNZ Marketing y Comunicación, S.L.
Rambla Catalunya 120 4º 4ª
08008 - Barcelona
Tel.: +34 93 528 57 89
Fax: +34 93 528 76 13
E-Mail: ralmeida@blanz.es
www.blanz.es
Company Contact
/ Denmark:
Baumer A/S, Mark van den Bosch, Jacob Knudens Vej 14, DK-8230 Aabyhoj
Tel.: +45 (0) 89 31 76 11, Fax: +45 (0) 86 25 65 77, E-Mail: info.dk@baumerprocess.com
Company Contact
/ Sweden:
Baumer A/S, Mark van den Bosch, Södra Lundavägen 10 - Box
117, SE-245 22 Staffanstorp
Tel.: +46 (0) 4623 4470, Fax: +46 (0) 4623 4479, E-Mail: info.se@baumerprocess.com
|
